Driveway cleaning in Middletown, NY

Driveway cleaning is the pressure washing of concrete — the slab, the front walks, the garage apron, and the patio pad — for homeowners in Middletown, Monroe, Newburgh, and the rest of Orange County, NY. Concrete can take real pressure, so this is the job where the surface cleaner runs at full strength. It removes algae, tire film, leaf stains, and ground-in dirt. It does not remove every oil stain, seal the slab, or repair cracks, and the estimate says so in writing before you book.
Where pressure belongs — and where it does not
A driveway is washed with a surface cleaner, a spinning bar under a hood that passes over the slab and cleans evenly. A wand alone leaves arc stripes that show every pass; the surface cleaner avoids that. We check the slab first — spalling, cracks, and a weak top layer change the pressure we use, and a slab that is crumbling gets a lighter pass or a polite decline. Edges, the apron where the garage door meets the slab, and tight corners get finished by hand with the wand.
What pressure washing does not belong on: your siding, your roof, your wood deck. Each of those has its own page and its own method. The house wash is a soft wash, the roof is never pressure-washed, and the deck runs at wood-safe pressure.
When an Orange County driveway needs it
Concrete here ages in specific ways. Shaded sections under maples turn green with algae and get slick in the rain — that film is a slip hazard as much as an eyesore. Well water in the rural parts of the county leaves rust-colored streaks under spigots and down the apron. Winter is the real grinder: freeze-thaw pushes water through the pores, and every plow season the slab takes salt and sand that grind into the surface. Most driveways in the area want a wash every year or two, and the practical season runs April through October, once the frost is out of the ground.
How the wash runs
We start by clearing the slab — cars out, and anything that lives on the driveway moved to the lawn. A pre-treatment goes on the stained and grown areas, then the surface cleaner makes its passes, working from the garage outward so the dirty water runs toward the street, not back under the house. The apron and edges are finished by hand, and we rinse the whole slab down at the end so no dirty film dries on it.
Before we leave we walk the slab with you and point at the spots that will remain: the oil ghost under where the old car sat, the rust shadow from the well-water downspout, the pop-out where a winter popper took a chip. Oil soaks deep into concrete pores; degreaser and agitation can lighten it, and a decade-old stain usually leaves a shadow no matter who washes it. If a stain matters to you — say, the full slab before a sale — tell us at the estimate so we can price a degrease treatment honestly instead of promising the base wash will do it.
What is included, and what costs extra
- Included: the concrete surfaces listed on the estimate, pre-treatment of grown and stained areas, the surface cleaner pass, edge and apron work by wand, and a final rinse.
- Often extra: heavy degreasing for oil-soaked slabs, rust treatment, and separate structures like shed pads and pool decks.
- Not included: concrete sealing, crack repair, resurfacing, and asphalt sealcoating — those are other trades.
What affects the cost
Square footage comes first, then condition. A sound rectangular two-car slab in open sun is the simplest job in the book. A long, L-shaped drive under trees, a slab with years of oil drips, or a yard with a locked gate and 200 feet of hose run all cost more time. Severity matters too — light film rinses off where a green, slick slab needs pre-treatment and dwell time. We do not quote exact prices by phone; the written estimate names each surface and the price before work begins.
Questions homeowners ask about driveway cleaning
Will the oil stains come out?
They usually lighten; they rarely disappear. Fresh oil sits near the surface and responds to degreaser and agitation. Old oil that has soaked in for years leaves a ghost that washing cannot reach. We treat what we can and tell you at the estimate which stains are which, so a remaining shadow is not a surprise.
Will high pressure damage the concrete?
Sound concrete handles a surface cleaner well. Weak concrete — spalling, flaking, or a slab that is crumbling at the edges — needs a lighter touch, and we adjust or decline rather than chew up the top layer. That check happens before a price is locked.
Can you wash the driveway and the house the same day?
Often, yes, and it saves a trip charge. The driveway runs at full pressure and the house runs soft wash, so the crew switches methods between the two. List both on the estimate so each surface and its price is in writing.
Do I need to be home?
No, as long as the cars are moved, the water spigot is accessible, and we know which gates are unlocked. We photograph the before and after for the invoice and leave the estimate copy on the door.

Recent driveway cleaning work
“Our slab is older than I am and it came out looking like the day it was poured, minus the two oil ghosts under my husband’s truck — and they told me those would stay before they started. Even, no stripes, done in about two hours.”
Tom B. · Monroe · Driveway cleaning“They washed the driveway and the front walk before my daughter’s graduation party. The estimate mentioned the rust streak from our well water might stay visible, and it did, though lighter. Everything else looked sharp, and they were careful with the beds along the garage.”
Angela M. · Newburgh · Driveway and walkwayBefore you book
Tell us about parked vehicles, tight access, and any stains you want checked. We serve Middletown and Orange County; call to confirm your location and the surfaces to include.
Questions about driveway cleaning
Where do you offer driveway cleaning?
Minisink Soft Wash works from Middletown, NY 10940. Towns on the regular schedule include Middletown, Newburgh, Cornwall, Goshen, Warwick, Monroe, and Washingtonville. If you are outside that list, call (845) 210-4477 and ask before you count on a visit.
How does an estimate work?
Call (845) 210-4477 or email hello@minisinksoftwash.com. We look at the slab — size, condition, stains, and access — and write what is included and what is not. A photo helps but is not enough for a firm price when the condition of the concrete changes the work.
What is included in driveway cleaning?
The written estimate lists each concrete surface: pre-treatment of grown and stained areas, the surface cleaner pass, edge and apron work by wand, and a final rinse. Sealing, crack repair, and resurfacing are not part of a wash.
Will oil and rust stains come out?
They usually lighten; they rarely disappear. Fresh oil responds to degreaser and agitation. Old oil that has soaked in for years, and rust shadows from well water, stay visible no matter who washes it. We say which is which at the estimate.
Will you use the driveway tip on the house?
No. Siding needs low pressure; a driveway tip can force water behind the laps and damage the finish. Each surface gets the method that fits it.
Does washing seal or repair the concrete?
No. Washing cleans the surface. Sealing, crack repair, and resurfacing are separate trades, and we will point you to them if that is what the slab needs.
How soon can you start?
It depends on jobs already booked. After the walkthrough you get a start window. We do not promise same-day.
